Dyson Light/Slim Ball repair
Dyson Light/Slim Ball Filter Service
pre-motor and post-motor filter locations shown in the exact owner guide must be serviced according to the exact owner guide; filter count, location, washability, and drying instructions differ across Dyson platforms. This procedure is scoped to the Light/Slim Ball (UP16) and its corded Dyson upright platform.
Exact applicability
Machines covered by this guide
- Light/Slim Ball machine code UP16
- Light Ball Animal Exclusive
- Light Ball Origin Exclusive
- Slim Ball Animal
- Slim Ball Multi Floor
- UP16 Multi Floor Exclusive
Repair scope
Before you order a part
- Repair path
- Owner maintenance / DIY
- Difficulty
- Basic owner maintenance
- Time
- 20–40 minutes
Order only a genuine replacement listed for Light/Slim Ball (UP16) after the failed assembly is confirmed; family-name resemblance does not establish compatibility.
Instructions
How to complete this repair
- Bright flashlight
- Clean lint-free cloth
- Cold running water only when the exact filter is marked washable
- Turn the vacuum off, unplug it by holding the plug, and let it cool before removing the bin, hose, wand, cleaner head, or filter cover.
- Use only owner-access points and maintenance actions documented for the exact machine code.
- Never reinstall a washable filter until it is completely dry for the full period specified in the exact owner guide.
- Do not wash a filter, cyclone, dock filter, or electronic assembly unless the exact model guide explicitly says it is washable.
Confirm the Light/Slim Ball configuration
Light/Slim Ball (UP16) is a bagless corded upright with a electrically driven cleaner head, clear bin, upright body, and removable hose and wand. UP16 Light Ball and Slim Ball retail variants share a working U.S. support route under Slim Ball and use a powered cleaner-head connection rather than a user belt.. Cataloged variants include Light Ball Animal Exclusive, Light Ball Origin Exclusive, Slim Ball Animal, Slim Ball Multi Floor, UP16 Multi Floor Exclusive. Match the machine code and serial label before ordering a filter where fitted, cleaner head, bin, hose, wand, or external seal; a retail family name can cover incompatible hardware.
Locate every filter for this platform
Use the model source to locate pre-motor and post-motor filter locations shown in the exact owner guide. Do not substitute the filter layout from another Dyson model family.
Inspect before cleaning
Check for heavy dust loading, tears, deformation, odor, moisture, a missing seal, or a filter that will not seat and lock. Replace a damaged or permanently restricted filter rather than forcing it into place.
Wash only a documented washable filter
If the exact guide marks the filter washable, remove loose dust, rinse it with cold water using the documented method, expel excess water without damaging the media, and leave it in a warm, ventilated place for the specified drying period. Do not use detergent, a dishwasher, microwave, dryer, or open flame.
Refit and verify the seal
Install only a completely dry filter in the correct orientation. Confirm its cover closes flush and the filter cannot bypass dust around its edge. Make a short test and stop if airflow, odor, heat, or a filter warning persists.
Sources and review
Guide references
Official references used for machine identity, safety, and owner-access boundaries.
Repair options
Repair it yourself or book professional service
Related repairs
Other possible repairs for your Light/Slim Ball
These are other repair paths applicable to this model.