Dyson 360 Vis Nav repair
Dyson 360 Vis Nav Bin Repair
top-mounted robot bin should empty, close, seal, and latch without forcing; diagnose its exact container, inlet, latch, and seal system instead of substituting another Dyson family's procedure. This procedure is scoped to the 360 Vis Nav (RB03) and its 360 Vis Nav robot platform.
Exact applicability
Machines covered by this guide
- 360 Vis Nav machine code RB03
Repair scope
Before you order a part
- Repair path
- Owner maintenance / DIY
- Difficulty
- Basic owner maintenance
- Time
- 20–40 minutes
Order only a genuine replacement listed for 360 Vis Nav (RB03) after the failed assembly is confirmed; family-name resemblance does not establish compatibility.
Instructions
How to complete this repair
- Bright flashlight
- Soft dry brush
- Clean lint-free cloth
- Switch the robot off and unplug its charging dock before removing the bin, filter, brush bar, or owner-removable battery cover.
- Use only owner-access points and maintenance actions documented for the exact machine code.
- Do not wash the cyclone, powered body, robot, dock, or bin assembly unless the exact owner guide explicitly marks the removed part washable.
Confirm the 360 Vis Nav configuration
360 Vis Nav (RB03) is an RB03 camera-guided dry robot with a full-width brush bar, edge actuator, wheels, and a charging dock. Match the machine code and serial label before ordering a filter, bin, brush bar, battery where owner-replaceable, or dock assembly; a retail family name can cover incompatible hardware.
Empty before the maximum-fill mark
Remove and empty the top-mounted robot bin using the documented release. Keep the opening downward and avoid forcing the ejector, lid, or latch.
Clear the inlet and closing surfaces
Use a soft dry brush or cloth to remove compacted dust from the inlet, outlet screen, shroud area that the guide exposes, lid edge, latch, and sealing surfaces. Do not insert tools into the cyclone or motor inlet.
Inspect the complete container
Look for cracks, a warped lid, a missing or rolled seal, a loose hinge, or a latch that will not hold. Replace the complete owner-removable container or documented seal rather than gluing a structural or sealing surface.
Refit and confirm a flush seal
Install the empty, dry container in the documented orientation. Confirm the lid and container click fully into place, then make one short test. Stop if dust escapes, the bin loosens, or airflow remains weak.
Sources and review
Guide references
Official references used for machine identity, safety, and owner-access boundaries.
Repair options
Repair it yourself or book professional service
Related repairs
Other possible repairs for your 360 Vis Nav
These are other repair paths applicable to this model.