Dyson 360 Vis Nav repair
Dyson 360 Vis Nav Filter Service
washable RB03 filter must be serviced according to the exact owner guide; filter count, location, washability, and drying instructions differ across Dyson platforms. This procedure is scoped to the 360 Vis Nav (RB03) and its 360 Vis Nav robot platform.
Exact applicability
Machines covered by this guide
- 360 Vis Nav machine code RB03
Repair scope
Before you order a part
- Repair path
- Owner maintenance / DIY
- Difficulty
- Basic owner maintenance
- Time
- 20–40 minutes
Order only a genuine replacement listed for 360 Vis Nav (RB03) after the failed assembly is confirmed; family-name resemblance does not establish compatibility.
Instructions
How to complete this repair
- Bright flashlight
- Clean lint-free cloth
- Cold running water only when the exact filter is marked washable
- Switch the robot off and unplug its charging dock before removing the bin, filter, brush bar, or owner-removable battery cover.
- Use only owner-access points and maintenance actions documented for the exact machine code.
- Never reinstall a washable filter until it is completely dry for the full period specified in the exact owner guide.
- Do not wash a filter, cyclone, dock filter, or electronic assembly unless the exact model guide explicitly says it is washable.
Confirm the 360 Vis Nav configuration
360 Vis Nav (RB03) is an RB03 camera-guided dry robot with a full-width brush bar, edge actuator, wheels, and a charging dock. Match the machine code and serial label before ordering a filter, bin, brush bar, battery where owner-replaceable, or dock assembly; a retail family name can cover incompatible hardware.
Locate every filter for this platform
Use the model source to locate washable RB03 filter. Do not assume the robot and its dock use the same maintenance method.
Inspect before cleaning
Check for heavy dust loading, tears, deformation, odor, moisture, a missing seal, or a filter that will not seat and lock. Replace a damaged or permanently restricted filter rather than forcing it into place.
Wash only a documented washable filter
If the exact guide marks the filter washable, remove loose dust, rinse it with cold water using the documented method, expel excess water without damaging the media, and leave it in a warm, ventilated place for the specified drying period. Do not use detergent, a dishwasher, microwave, dryer, or open flame.
Refit and verify the seal
Install only a completely dry filter in the correct orientation. Confirm its cover closes flush and the filter cannot bypass dust around its edge. Make a short test and stop if airflow, odor, heat, or a filter warning persists.
Sources and review
Guide references
Official references used for machine identity, safety, and owner-access boundaries.
Repair options
Repair it yourself or book professional service
Related repairs
Other possible repairs for your 360 Vis Nav
These are other repair paths applicable to this model.