Dyson V10 Konical repair
Dyson V10 Konical Cleaner Head Repair
The complete dual-conical cleaner head should be isolated from its owner-removable connections before a powered-head motor, control, or whole-head failure is considered. All Floor Cones powered head uses dual conical brush bars and illumination; it is distinct from the original Cyclone V10 floor heads. This procedure is scoped to the V10 Konical (SV55-AE) and its cordless Dyson stick-vacuum platform.
Exact applicability
Machines covered by this guide
- SV55-AE
- V10 Konical
- V10 Konical with Auto-empty Dok
Repair scope
Before you order a part
- Repair path
- Owner maintenance / DIY
- Difficulty
- Basic owner maintenance
- Time
- 20–40 minutes
Order only a genuine replacement listed for V10 Konical (SV55-AE) after the failed assembly is confirmed; family-name resemblance does not establish compatibility.
Instructions
How to complete this repair
- Bright flashlight
- Scissors or a seam ripper for wrapped fibers
- Soft dry brush
- Clean lint-free cloth
- Power the vacuum off, disconnect its charger, and remove a detachable battery only when the exact owner guide describes that action.
- Use only owner-access points and maintenance actions documented for the exact machine code.
- Do not cut toward the brush surface, wiring, soft roller, or cleaner-head housing.
- Do not open a brush motor, gearbox, powered-head wiring channel, or sealed bearing housing.
Confirm the V10 Konical configuration
V10 Konical (SV55-AE) is a bagless cordless body with a wand and dual-conical cleaner head. Cataloged variants include V10 Konical, V10 Konical with Auto-empty Dok. The verified owner-service profile identifies it as the Dyson V10 Konical cordless platform. Match the machine code and serial label before ordering a filter, bin, wand, cleaner head, battery, or charger; a retail family name can cover incompatible hardware.
Isolate the complete powered head or tool
Follow the exact owner guide to detach the dual-conical cleaner head as a complete owner-removable assembly. All Floor Cones powered head uses dual conical brush bars and illumination; it is distinct from the original Cyclone V10 floor heads. Detach the floor tool or cleaner head from the machine before working around the brush.
Rule out a brush jam inside the head
Cut and lift away hair, thread, and fibers in small sections. Remove debris from accessible end-cap and inlet areas without prying off a sealed bearing or gear cover. Check for melted fibers, cracks, distortion, or an end that remains seized.
Check the platform-specific connection
Inspect the external electrical contacts and latches between the dual-conical cleaner head and the next owner-removable assembly. Contacts must be dry, clean, straight, and free of scorching. This is not a belt-replacement path.
Make one controlled brush test
Reassemble the machine completely and test the dual-conical cleaner head briefly on a clear, suitable surface. Stop if it stalls again, pulses, smells hot, shows an error, or makes a grinding noise.
A brush that remains stationary after debris and external connections are checked needs professional cleaner-head, drive, or control diagnosis.
Sources and review
Guide references
Model-profile procedure reviewed 2026-07-11 against the exact machine identity and owner-access references below.
Repair options
Repair it yourself or book professional service
Related repairs
Other possible repairs for your V10 Konical
These are other repair paths applicable to this model.